Electrohome RV-3798 - Manual (Page 20)

18
Remote Control
Your remote control is capable of operating most RCA audio
and video equipment. To use the remote control effectively,
always aim it directly at your receiver.
The remote control operates on four batteries, included with
your system. Install them before attempting to operate the
remote. Be sure to match the
+ and
-
ends of each battery to
the symbols shown in the remote’s battery compartment.
Basic Controls
POWER Turns the AM/FM receiver off with one press. If you
have multiple components turned on and not the AM/FM
receiver, pressing POWER once turns off the last component
turned on. Pressing POWER again quickly turns off all other
components.
VOL UP and DOWN Increases or decreases the volume.
MUTE Turns off the receiver’s sound. Press again to restore
the sound.
Receiver Controls
AM•FM Activates the tuner and toggles between the AM
band and the FM band.
CTR MODE Changes the Center mode when using Dolby
Pro-Logic Surround or Dolby
3 Stereo surround modes. Press
once and the current mode appears. Press again to change
the mode.
DELAY/CH CTRL Selects the amount of Surround Sound delay
between the main and rear speakers. Choose from 15, 20 or
30 milliseconds. Press once and the current setting appears.
Press again to change the setting.
SURROUND Lets you select a Surround Mode: Dolby
Pro Logic Surround, Dolby 3-Stereo, Hall or By-Pass. Press once
and the current mode appears. Press again to change the
mode.
SWAP AUDIO Swaps the audio only from the large picture to
the small picture when you are watching TV and using
picture-in-picture (PIP).
Tour of the Receiver
ENTER
FWD
GO BACK•DISC
PLAYLIST
SWAP
AUDIO
SKIP
DVD
SAT•CABLE TV
POWER
VCR
TAPE CD AM•FM
PLAY REV
STOP PAUSE REC
GUIDE•RDM
MUTE
CH+
V
O
L
V
O
L
CH-
1 2 3
6 5 4
7 8 9
0
INPUT•SEEK ANTENNA
INFO CLEAR RESET•REP
MENU
MOVE
TV MENU
SWAP PIP
CTR MODE
PIP
SELECT
BY-PASS LEVEL
REAR
CTR •
DELAY
CH CTRL
S
U
R R O U N
D
– +
LD•VCR 2