Eiki LC-XG250L - Manual (Page 8)

- 8 -
Rear Terminal
q w e
r
t
y i u
t USB CONNECTOR (Series B)
Use this connector when controlling a computer
with the remote control of the projector. Connect
the USB terminal of your computer to this
connector with the supplied USB cable.
y S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack.
i AUDIO 2 JACK
Connect the audio output (stereo) signal from a
computer or video equipment to this jack.
o AUDIO 1 JACK
Connect the audio output (stereo) signal from a
computer or video equipment to this jack.
r VIDEO INPUT JACK
Connect the composite video output signal from
video equipment to this jack.
u AUDIO 3 JACKS (L(MONO)/R)
Connect the audio output signal from video
equipment to these jacks. For a mono audio signal
(a single audio jack), connect to the Mono input
jack.
q 5 BNC INPUT JACKS
Connect the component or composite video output
signal from video equipment to VIDEO/Y, Cb/Pb,
and Cr/Pr jacks or connect the computer output
signal (5 BNC Type [Green, Blue, Red, Horiz. Sync,
and Vert. Sync.]) to G, B, R, H/V, and V jacks.
w COMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output signal
to this terminal.
e COMPUTER INPUT TERMINAL (DIGITAL)
Connect the computer output signal (Digital DVI-D
type) to this terminal. The HD (HDCP compatible)
signal can also be connected.
o