El Paso Chile Company DMS 3080-80 - Manual (Page 26)

PAGE 26
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE DMS3040/3080/3120
INSTALLATION AND WIRING
USING SPEAKERS FOR ZONE 1 - ZONE 2
3120 Zone 1&2
2 4 5
SER. NO. CLASS 2 WIRING ACCEPTABLE
COM 8 25V 70V
SPEAKER OUTPUT
GROUND
LINE FUSE
5A 250V
117V 500W MAX
117V 60HZ
LEVEL LEVEL
VOX-1
UNSWITCHED
0 600
ZONE 2 ZONE 1
0 8 0 8
SENS
ZONE 2 ZONE 1
POWER RATING
SUPPLY VOLTAGE
POWER CONSUMPTION
DIGITAL MUSIC AMPLIFIER
CAUTION: TO REDUCE THE
RISK OF FIRE, REPLACE
ONLY WITH SAME TYPE
FUSE.
MOH OUT
BALANCED
PROFESSIONAL AUDIO & SOUND
1 WATT 1 WATT
MODULE
JUMPER
SW701
AU
X
1
AU
X
2
ZONE 2
INPUT SOURCE
DEFAULT JUMPER
SETTING
ZONE 1 OUTPUT LEVEL CONTROL
AWG 18
TWISTED PAIR
Up to Four 8 ohm Speakers may
be Connected
1/4W
1/4W
1/4W
1/4W
8
OHM
ZONE 1
AWG 18
TWISTED PAIR
4 Speaker System Max. Power Output= 1/4W Each 1/4W
1/4W
1/4W
1/4W
8
OHM
8
OHM
8
OHM
8
OHM
8
OHM
8
OHM
8
OHM
Up to Four 8 ohm Speakers may
be Connected
ZONE 2
ZONE 2 OUTPUT LEVEL CONTROL
MODULE
JUMPER
SW702
AU
X
1
AU
X
2
MOH - ZONE 1
INPUT SOURCE
DEFAULT JUMPER
SETTING
6
Fig. 26 - Rear Panel Zone 1 and 2 Speaker Connection Diagram
ZONE 1 AND 2 OPERATION
The Amplifier is equipped with two independent 1 Watt, 8
ohm Outputs designated ZONE 1 (Reference 4) and ZONE
2 (Reference 5). The Outputs may be utilized to power up to
4 speakers in various combinations as described in the dia-
grams on the next page. This feature will provide a SEC-
OND and THIRD ZONE (in addition to the main output) with
up to 1 Watt of output power and will amplify only the
Source from either AUX 1 - AUX 2 or MODULE (see input
source selection) and will not be affected by the Paging
(from MIC or TEL), VOX or MUTING.
It can be used in any area (up to 1 Watt) where only a
Program Source is desired uninterrupted by Paging.
CABLE
Use an AWG 18 jacketed, twisted pair cable.
ZONE 1 AND 2 OPERATION ZONE 1 AND 2 SETTINGS
INPUT SOURCE SELECTOR
Independent JUMPER SETS for ZONE 1 (SW702) and
ZONE 2 (SW701) are available to select the Input Source
for the two 1 Watt Amplifiers.
DUAL PROGRAM SOURCE CAPABILITY
If desired separate program Sources may be used for
ZONE 1 and ZONE 2.
EXAMPLE: Use the program source from AUX 1 for ZONE
2 and the program source from AUX 2 for ZONE 2.
Select the Input Source desired by following the instructions
in the MOH Amplifier Source Selection section.
LEVEL CONTROL
After the wiring is completed adjust the ZONE 1 (
Reference
2) and ZONE 2 ( Reference 6) Level Controls on the rear
panel to the desired output level.
PROFESSIONAL AUDIO & SOUND
® TM
DIGITAL MUSIC SERIES
DIGITAL MUSIC AMPLIFIERS