Kichler 339022 - Manual (Page 7)

6
Fig. 7
Fig. 8
8. INSTALLING THE MOTOR HOUSING
Remove the four sets of nuts and washers
located on the mounting plate threaded studs.
Hang the motor assembly from the hook on
the ceiling mounting plate by placing the hook
into a hole on the mounting plate.
Place the wires and connections inside the
mounting plate and the ceiling mounting plate.
Swing the motor assembly up into position
under the ceiling mounting plate, align the
holes on the mounting plate with the four studs
on the ceiling mounting plate and push the
motor assembly onto the studs. Secure with
the four nuts and washers you removed
earlier. (Fig. 7)
Ceiling
mounting
bracket
Motor
Motor
housing
Ceiling mounting
plate
Screws
Motor assembly
Washer
Washers
Nut
Nut
Mounting plate
Remove the four screws located on the
outside edge of the ceiling mounting plate.
Lift the Motor Housing up and align the
mounting holes in the housing to the mounting
holes on the ceiling mounting plate.
Insert each mounting screw rotating first one
side to the other and then tighten each screw
after all four have been started. (Fig. 8)
7. FINISHING THE INSTALLATION
52" Stratmoor TM
Mounting plate
threaded studs