Kichler 339520 - Manual (Page 9)

8
9. ATTACHING THE FAN BLADES
Fig. 16
CAUTION: Remove the five rubber shipping
blocks attached to the face of the motor.
These blocks keep the motor from shifting
during shipping and MUST be removed during
installation.
Step 1. Attach the blade to the blade bracket
using the screws and rubber washers as
shown in Figure 16. Start screw into bracket.
Repeat for the two remaining screws.
Step 2. Make sure the blade is straight and
tighten each screw.
Step 3. Fasten blade assembly to motor using
"Pre-Installed" mounting screws in the blade
bracket.
Sterling Manor Patio
TM
Screws Blade
Blades bracket
Screws
Rubber
washers