Ericsson KRD 103 117/1 - Manual (Page 13)

Channel Scan
In the scan mode, the radio alternately monitors each
Channel until it receives a call. You can scan all Channels,
or you can temporarily lock out individual Channels from
scanning as desired.
1. Press S to begin
scanning. The SCAN
indicator begins to flash.
2. The radio stops on any Channel that receives a call, and
you hear the caller. When the transmission stops, the
radio resumes scanning after a brief delay.
3. To disable scanning, press S .
Dual Watch
If your radio has been programmed with a Priority Channel,
the radio will sample the Priority Channel between any other
receiving Channel during Scan Mode. This is usually the
Channel you use for most of your communications.
During scan the PRI indicator
will flash whenever the Priority
Channel is being monitored.
Create a Channel Scan List
with Channel Lock Out
Deleting channels (from the channel scan list) increases the
scanning speed.
Use < or > to select the
desired channel and press
L . The locked-out channel
blinks, and the DEL indicator
appears.
To remove the lock-out condition from a channel, manually
select the channel and press
L again.
Drop Out Delay
While scanning, the radio stops at a busy channel and
receives a transmission. When the received call is over, it
resumes scanning after a short delay (programmable).
Transmit
1. Use < or > to select the desired channel.
2. Before you transmit, press M and listen for activity on
the channel. Also check the Transmit/Receive Indicator.
If it is blinking RED, the Channel is locked out, and you
cannot transmit.
08 SCAN
05
PRI
SCAN
03 DEL
- 13 -