Euphonix System Digital Audio Mixing System 5B - Manual (Page 85)

System 5-B Digital Audio Mixing System Operation Manual Busses and Bus Masters
85
Individual Main Busses
The right side of Figure 7-2 shows the individual Main Bus display selected by pressing
the upper of the two buttons to the left of each knob. The important functionality is sum-
marized below:
• Press the lower of the two buttons to the left of each knob to turn the individual
bus On/Off. Its level is retained if that bus is turned on after being off.
• Adjust the knob to set the level for that bus.
7.2.6 Group and Aux Busses
The Group and Aux Bus Masters have the same controls. Press the Grp Mstrs or Aux
Mstrs button to display the first eight Group or Aux Bus Masters. Use the W and X
keys to display additional busses. The knobs control the bus levels and the lower button
to the left of the knob turns that bus on/off. See Law Palette on page 49 to learn how to
select the format.
7.2.7 Configuring Aux Busses
With the Aux Busses on the Bus Master knobset, press both cfg W and X keys simul-
taneously (these keys are usually pressed individually to page between groups of eight
busses) to display the Aux Bus Settings in the Quick Access Panel. Both cfg keys flash
to designate the Aux Bus configuration mode.
Each button pertains to an Aux function discussed in the following sections.
Figure 7-3 Aux Bus Settings
NOTE: The number of aux busses (16 or 24) depends on the Mixer Model.
U n i t y
P r e / P o s t
O n / O f f
S t e r e o
A u x T o F a d e r
A u x C o p y
F a d e r C o p y