Florabest FMH 2400 A1 - Manual (Page 42)

42
MT GB
• Guarantee is conditional on adherence
to instructions on cleaning and servic-
ing instructions.
• Damage resulting from material or
manufacturing defects shall be rem-
edied by replacement or repair free of
charge.
• Our service centre will also repair parts
not covered by guarantee for a fee.
The service centre will be pleased to
give you a cost estimate.
We can only repair equipment with suf-
ficient postage and packaging by the
sender.
• This requires you to return the non-
dismantled unit together with its
receipt slip and warranty card to our
Service Centre.
• We will not accept bulk consign-
ments, express or other special
freight where postage has not been
paid for.
• We will dispose of your equipment free
of charge.
Technical specifications
Blade-type shredder .......... FMH 2400 A1
Nominal power intake ...................2400 W
Nominal voltage .......... 220V-240 V, 50 Hz
Safety class ....................................... II
Degree of protection ..........................IP24
Idling speed (n
0
) ........................3940 min -1
Branch thickness ................. max. 40 mm*
Volume of collection bag................ca. 60 l
Weight ..............................................12 kg
Guaranteed sound power level
...................................................107 dB(A)
Measured sound power level (LwA)
..........................106 dB(A); KwA= 1 dB(A)
Acoustic pressure level (LpA)
.........................86,4 dB(A); KpA = 1 dB(A)
The sound levels have been determined
in accordance with noise measuring pro-
cess EN 13683:2009-09, appendix F.
* The max. branch thickness that can be chaffed is
dependent on the type of wood and the quality of
the goods being cut.
For hard wood (e.g. oak/beech branches), the
max. branch thickness that can be chaffed is less
than for soft wood (e.g. pine/spruce wood). For
dry or knotted wood, the cutting thickness may
also be less.
≥100A
The equipment is intended only
for use in premises in which the
current bearing capacity of the
network is >=100 A per phase
and which are supplied by a
distribution grid with a nominal
voltage of 400/230V.
To be on the safe side, check with your
local electric utility to verify that the
junction point of the mains has enough
continuous current carrying capacity for
the unit.
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid.