Florabest FHA 1100 A1 - Manual (Page 7)

7
GB
- If there is a risk of flooding, fix the
plug connections in an area that is
safe from flooding.
• Ensure that the mains voltage match-
es the specifications on the rating
plate.
• The electrical installation shall be ac-
cording to national wiring rules.
• Connect the equipment only to a
socket with a residual current protec-
tion device (residual current circuit
breaker) with a rated current of not
more than 30 mA; minimum fuse 10
amperes.
• Before each use, check the equip-
ment, cable and plug for damage. De-
fective cables are not to be repaired,
but rather replaced by new ones.
Have any damage to your equipment
repaired by a specialist.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
fied person in order to prevent haz-
ards.
• Do not pull the plug from the socket
by the cable. Protect the cable from
heat, oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are
protected from spray water and de-
signed for outdoor use. Always fully
unroll a cable drum before use. Check
the cable for damage.
• Before any work on the equipment,
during work breaks and in the case
of non-use, remove the plug from the
socket.
• The cross-section of mains connec-
tion lines must be no smaller than
rubber hose lines with the designation
H07RN-F. The line must be 10 m long.
Areas of Application
The home water dispenser is intended for
use in private homes and gardens. The
unit is suitable for service water supply and
the irrigation of gardens. It is solely intend-
ed for pumping clear and rain water up to
temperatures of no more than 35°C.
Any other use, not expressly authorised
in these instructions (e.g. for transport-
ing foodstuffs, salt water, motor fuels,
chemical products or water with abrasive
materials), may cause damage to the
equipment and represent a serious risk for
the user.
The home water dispenser is not suitable
for continuous duty. Continuous operation
reduces the durability and shortens the
guarantee period.
The operator or user is responsible for ac-
cidents or damage to other people or their
property.
The manufacturer shall not be liable for
damages caused by use other than for
which the equipment is intended or by incor-
rect operation.
General Description
Functional description
The home water dispenser pumps water
automatically. The pump will turn on and
convey water at turn-on pressure. The turn-
on point is set in the factory and cannot be
adjusted by the user.
Read the sections below to learn more
about each operating element’s function.
The diagram of the most impor-
tant functional elements can be
found on the foldout side.