Epson EB 1735W - Manual (Page 70)

Problem Solving 70
f Interference or distortion appear in images
f The image is truncated (large) or small, or the aspect is not suitable
Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient
temperature changes occur, condensation may form on the surface of the lens, and this may cause the images
to appear fuzzy. Set the projector up in the room about one hour before it is used. If condensation forms on the
lens, turn the projector off and wait for the condensation to disappear.
Check Remedy
Is the image signal format setting correct? Change the setting according to the signal for the connected equipment. s "Signal" - "Video Signal" p.41
Are the cables connected correctly? Check that all the cables required for projection are securely connected. s Quick Start Guide
Is an extension cable being used? If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the
projector to check if the cables you are using may be causing the problem.
Is the correct resolution selected? Set the computer so that the signals being output are compatible with the projector.
s
"List of Supported Monitor Displays" p.103 s Computer documentation
Are the "Sync. g " and "Tracking g " settings adjusted
correctly?
Press the [Auto] button on the remote control or the [Enter] button on the control panel to perform automatic
adjustment. If the images are not adjusted correctly after using automatic adjustment, you can make the
adjustments using "Sync." and "Tracking" from the configuration menu. s "Signal" - "Tracking", "Sync."
p.41
Check Remedy
Is a wide panel computer image being projected? Change the setting according to the signal for the connected equipment. s "Signal" - "Resolution" p.41
Is the image still being enlarged by E-Zoom? Press the [Esc] button on the remote control to cancel E-Zoom. s p.25
Is "Position" adjusted correctly? Press the [Auto] button on the remote control or the [Enter] button on the control panel to perform automatic
adjustment of the computer image being projected. If the images are not adjusted correctly after using
automatic adjustment, you can make the adjustments using "Position" from the configuration menu.
Apart from computer image signals, you can adjust other signals while projecting by adjusting "Position"
from the configuration menu. s "Signal" - "Position"
p.41
Check Remedy
Only when projecting images from a video source
Only when projecting computer images
Only when projecting computer images
Only when projecting computer images