Florabest FKS 2200 B1 - Manual (Page 13)

13
GB
The tool is completely assembled on deliv-
ery.Before you start up the electric chain-
saw, adjust the chain, fill up with chain oil
and check the automatic lubrication and
chain brake function.
Note that the saw can re-oil.
Please note that the saw re-oils after use
and oil may leak out if it is stored on its
side or on the head. This is a normal
process due to the necessary ventilation
opening on the upper edge of the tank and
does not constitute a reason for complaint.
As each saw is checked during production
and tested with oil, a small residue may
be in the tank despite draining, which may
slightly dirty the housing with oil in transit.
Please clean the housing with a cloth.
Tensioning the saw chain
With a correctly tensioned chain you get
good cutting performance and a longer
life.
. An.incorrectly.tensioned.
chain.may.break.or.spring.
off,.leading.to.danger.of.
injury..Test.the.electric.saw.
before.every.start.and.the.
chain.tension.after.every.
hour.of.sawing.
The chain is correctly tensioned if it does
not sag at the rail underside and can be
rotated completely around with the gloved
hand.
When the saw chain is tensioned with 9 N
(approx. 1 kg), the gap between the saw
chain and the guide rail may not be more
than 2 mm.
B 1. Ensure that the chain brake has
been released, that is, that the
chain brake lever (3) is pulled up
against the front grip (8).
2. Unscrew the fastening bolt (14).
3. To tighten the saw, turn the chain
adjustment ring (13) clockwise.
To loosen the tension, turn the
chain adjustment ring anti-clock-
wise.
4. Tighten up the fastening bolt (14)
again.
With a new saw chain, you must
readjust the chain tension after at
least 5 cutting operations.
Chain lubrication
The rail and chain must never be
without oil. If you operate the elec-
tric chainsaw with too little oil, the
cutting performance and the lifetime
of the saw chain is reduced, since
the chain becomes blunt faster. You
can identify a case of too little oil
where smoke development or dis-
coloration of the rail occurs.
The chainsaw is equipped with an auto-
matic oiling system. As soon as the motor
is speeded up, the oil also flows faster to
the chain bar (4).