Initial operation, Ie gb – Florabest FHA 1100 A1 User Manual

Page 8

Advertising
background image

8

IE

GB

Overview

A

1 Water outlet, automatic switch

2 Power cable, automatic switch

3 Water outlet, home water dis-

penser

4 Water inlet, home water dis-

penser

5 On/Off switch

6 Power cable, home water dis-

penser

7 Home water dispenser

8 Carrying handle

9 Water inlet, automatic switch

10 Automatic switch

11 Restart switch

12 “Power On” indicator

13 “Pump On” indicator

14 “Alarm” indicator

15 Rest

16 Thread of rest screw

17 Draining screw

18 Draining screw

B

19 Filler screw

Scope of Delivery

- Home water dispenser

- Automatic switch

- Rest

Initial Operation

Assembly

• Screw the rest (15) from the package

into the thread (16) in the bottom of

the home water dispenser (7).

• Push the carry handle (8) onto the

carry handle holder and screw these

together using the screws with was-

hers. To do this, use the hex key.

• To permanently install the home wa-

ter dispenser, screw it to the ground.

Screwing it to a fixing panel will pre-

vent the appliance from moving.

Mind not to obstruct the access to the

draining screw (17).

Mains Connection

The pump you have purchases is already

fitted with an earthed plug. The pump is

intended for connection to an earthed

socket at 230 V ~ 50Hz.

Setting up

• Place the unit on a firm, horizontal,

non-flooding surface.

• Always put up the home water dis-

penser at a point higher than the

water surface you wish to pump water

from.

Where this is impossible, install a low

pressure-resistant shut-off implement

between the appliance and the suc-

tion hose.

• Remove the cap from the home water

dispenser’s water outlet (

A

3). Mount

the automatic switch (

A

10) on the

home water dispenser’s water outlet

(

A

3).

Connecting the hoses

On the suction side, attach a hose

with reflow stopper and install a

prefilter. On the suction side, do

not use any quick-action connec-

tion systems.

• Attach a suction hose to the home water

dispenser’s water inlet fitting (

A

4).

• Attach a pressure hose to the automatic

switch’s water outlet fitting (

A

1).

Air in the suction hose will stop the

house water dispenser from work-

ing properly.

Advertising