Epson RS830 - Manual (Page 16)

16
4. Place a square (D) Fig. 32 on the table and against the
saw blade. See if the blade is square with the table.
NOTE: The square should rest between two teeth of the
saw blade.
5. To adjust, tighten the bevel clamp lever (C) Fig. 31.
6. Remove the screw, flat washer, and pointer (E) Fig. 31.
7. Remove the two screws (F) Fig. 31 and the bevel scale
plate (H) Fig. 32 with the index knob (A).
8. Loosen the four hex screws (G) Fig. 33. Tilt the motor
until the saw blade is flush with the square. Tighten the
four hex screws (G).
9. Replace the bevel scale plate (H) Fig. 33 with the bevel
index release knob (A), two screws, and pointer that
were removed earlier.
NOTE: Adjust the pointer to “zero” on the bevel index scale.
AdJUSTINg IN/OUT RIP SCALE
1. Loosen the yoke clamp handle (A) Fig. 34. Release
the yoke index by pressing the release lever (B) up or
down. Rotate the cuttinghead (C) to the in-rip position
(Fig. 34). Tighten yoke clamp handle (A).
2. Position the fence (D) Fig. 34 at the rear of the table.
3. Loosen the cuttinghead clamp knob (C) Fig. 34. Slide
the cuttinghead to the rear of the track arm until the
saw blade (F) is flush against the fence (D).
4. Tighten the cuttinghead clamp knob. Adjust the pointer
(H) Fig. 34 to the “zero” mark on the lower scale (J)
by loosening the screw (K). Tighten the screw when
finished.
Fig. 32
Fig. 33
d
g
H
A
Fig. 34
F
B
H
K
J
A
C
d
1. Attach the inside (thick) arbor flange (A) Fig. 35 to the
arbor shaft with the recessed side of flange (A) facing
out.
ATTACHINg THE BLAdE ANd BLAdE gUARd
NOTE: Use only 10" blades with 5/8" arbor holes and
rated for 5000 rpm or higher.
A
Fig. 35