Florabest FKS 2200 D2 - Manual (Page 61)

61
GB
Filling up with chain oil:
• Check the oil fill level ( C 21/22) and
regularly top up with oil. The oil tank
holds 270 ml oil.
• Use Parkside bio-oil; this product con-
tains additives that reduce wear and
tear and does not damage the pump
system. bio-oil is available from our
Service-Center.
• If you have no Grizzly bio-oil available,
use chain lubrication oil with low adhe-
sive additive content.
• Empty the oil tank before longer periods
(several month) of non-use
C 1. Unscrew the oil fill cap (2) and fill
up with chain oil.
2. Wipe off any spilled oil and
close the cap again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.
Operating the chainsaw
Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled. Ensure the voltage of the
mains connection agrees with the
label on the device. Make sure you
have a secure stance
Note: The saw is a high-powered
device, where a 13 A fuse gener-
ally suffices, provided that further
current consumers with high service
are not connected. However, if
the premises installations are not
implemented optimally and “quick-
acting” protection fuses are built-in
(e.g. B 16), the protection fuse
will be activated due to the current
peaks during switch-on. You should
install time-delay fuses with the des-
ignation “L”, which can be bought
in every hardware store. Fuses with
the designation “G” are provided
with even longer time delay, how-
ever they are not usually employed
in households.
Caution! Saw can oil up, see notes
on Operation startup.
Switching on
D
1. Check before the start, whether
sufficient chain oil is in the tank
and, if necessary, refill with chain
oil (see Chapter Operation Start).
2. Form a loop from the end of the
extension cable and hang this
into the tension relief (17) on the
rear grip (1).
3. Connect the device to the mains
voltage.
4. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
5. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear grip (1) and
the left hand on the front handle
(8). Thumb and finger must close
securely over the handles.
6. For switching on, activate the
switch-on block (11) with the right
thumb and then press the On/Off
switch (10), the electric power
saw runs with highest speed.
Release the switch-on block
again.