Shivaki STV-24LEDGW9 - Manual (Page 26)

REMOVE THE TV STAND
How to remove the TV stand
If you prefer to mount your new TV on a wall instead of attaching it to the TV stand, please remove the
TV stand from the TV unit before mounting the TV on the wall.
Read all instructions before continuing with the TV stand removal.
a. Open the box, and make sure all necessary parts are in the box. The TV is assembled with the TV
stand.
b.Cover an even stable surface with a soft cloth. Place the LED TV unit face-down on the cloth. Fit the
base onto the bottom of the LED TV unit as shown at
N O I T U L O S E L B I S S O P M E L B O R P
No sound and picture
- Check that the main plug has been connected to a wall outlet.
- Check that you have pressed the
button on the remote control.
- Check the picture contrast and brightness settings.
Normal picture but no sound
- Check the volume.
- Sound muted? Press the MUTE button.
- Try another channel the problem may be with the broadcast.
- Are the audio cables installed properly.
The remote control does not
work
- Check to see if there are any objects between the product and remote control
Causing obstruction.
- Are batteries installed with correct polarity (+ to +,- to -).
- Whether the remote control is out of its working distance or angle.
- Install new batteries
Power is suddenly turned off
- Is the sleep timer set.
- Check the power control settings. Power interrupted.
- No broadcasting on station. Check whether Off is selected in TIME menu under option Auto
Standby.
Picture appears slowly after
switching on
- This is normal, the image is muted during the product startup process.
Please contact your service center, if the picture has not appeared after
No or poor color or poor picture
- Adjust the color in menu option.
- Try another channel, the problem may be with the broadcast.
- Are the VIDEO cables installed properly?
Horizontal/vertical bars
or picture shaking - Check for local interference such as an electrical appliance or power
tool.
Poor reception on some
channels
- Station or cable product experiencing problems. Tune to another
station.
- Station signal is weak, reorient antenna to receive weaker station.
- Check for sources of possible interference.
Lines or streaks in pictures
- Check the antenna (Change the direction of the antenna).
No output from one of the
speakers - Adjust balance in menu option.
N O I T U L O S E L B I S S O P M E L B O R P
The signal is out of range
- Adjust resolution, horizontal frequency, or vertical frequency on input source.
- Check it whether the signal cable is connected or loose.
- Check the input source.
Vertical bar or stripe on
back ground & Horizontal Noise
& lncorrect position.
position.
Screen color is unstable or
single color.
- Check the signal cable.
- Reinstall the PC video card.
TROUBLE SHOOTING
Before contacting the service technician, perform the following simple checks. If any problem still
exists, unplug the TV and call the service hotline
NOTE: There is a problem in VGA mode. (Only VGA mode applied)
48 49
34