Melinera Z30252 - Manual (Page 4)

4 GB/IE
Z30252A-BS – transparent
Z30252B-BS – green
Z30252D-BS – yellow
Z30252E-BS – blue
Safety information
In the case of damage resulting from non-compliance
with these operating instructions the guarantee
claim becomes invalid! No liability is accepted for
consequential damage! In the case of material
damage or personal injury caused by incorrect
handling or non-compliance with the safety
instructions, no liability is accepted!
DANGER OF
DEATH AND ACCIDENTS FOR
TODDLERS AND CHILDREN!
Never leave children unsupervised with the
packaging material. The packaging material
represents a danger of suffocation. Children
frequently underestimate the dangers. Please
keep children away from the device at all times.
This device is not a toy and should not be played
by children. Children are not able to understand
the dangers that can occur when handling this
device.
Children or other individuals who do not know
or have no experience of handling this device,
or whose physical, sensory or mental abilities
are restricted, must not use the device without
supervision or instruction by an individual
responsible for their safety. Children must be
supervised in order to ensure that they do not
play with the device.
Avoid the danger of
death from electric shock!
Before use, ensure that the mains voltage
available is the same as the required operating
voltage for the device (230–240 V ∼).
Before connecting to the mains, always check
the product for any damage.
Never use the product if you find damage of
any kind.
The connecting cable cannot be repaired! If the
cable is damaged, the product must be taken
out of use and disposed of in the proper way.
This article does not contain any parts which
can be serviced by the user. The bulbs cannot
be replaced.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the product from sharp edges, mechanical
loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always remove the mains plug from the socket
before installing, dismantling or cleaning.
Never touch the mains plug or the LED rope
light 1 with wet hands.
CAUTION! RISK OF OVERHEATING!
Do not operate the LED rope light 1 in the
packaging or when it is rolled up.
Use the lighting only with the parts described
in these instructions.
If the LED rope light 1 is not to be used for
any length of time (e.g. holidays), disconnect
it from the power supply.
After use, keep the LED rope light 1 in the
packaging to prevent unwanted damage.
Keep away from ponds and other water reservoirs.
Install the LED rope light 1 at least 2 metres
away from water containers. Avoid place that
might flood after heavy rainfall.
This product is intended for use outdoors but
should be plugged into a socket which is located
in an indoor location (e. g. a shed, garage or
porch).
The socket into which this product is plugged
must be protected by a residual current circuit
breaker (RCD) with a trip current not greater
than 30 mA.
Sockets positioned outdoors for use with this
product should be of a type which is ade-
quately waterproof for an outdoor location
and should be located at least 2.5 m from the
nearest body of water or any location where
water may collect.