Operation / cleaning and care, Cleaning and care – Melinera Z30233A-BS/Z30233B-BS User Manual
Page 8
10 GB
Melinera
®
Operation / Cleaning and care
Turn the lamp shade
2
anticlockwise and pull it off the candle
body
3
. Then pull the candle body
3
from the LED light
set
1
.
CAUTION! RISK OF INJURY! Be very careful when you
are doing this. The bulbs
6
may otherwise be damaged.
Remove the faulty bulb
6
from the fitting
8
by bulb remover
7
(see Fig. B).
Plug a new bulb into the fitting
8
.
CAUTION! Make sure that the type, operating voltage and
wattage are correct. Never use other than the stated bulbs
6
.
CAUTION! The bulbs
6
have a plug-in system. Never
screw the bulbs
6
in. This can cause damage.
Note: the bulb
6
will only light up if it is fitted the right way
round. The marks on the bulb
6
and the fitting
8
have to be
in line with one another (see Fig. B). Remove the bulb
6
if it
does not light up and replace it in the opposite direction.
Note: make sure that the wires are pointing upwards and
that there is no foreign matter in the fitting
8
.
Place the candle body
3
back on to the LED light set
1
.
Then place the lamp shade
2
on the candle body
3
and
turn it clockwise to tighten it.
CAUTION! RISK OF INJURY! Be very careful when you
are doing this. The bulbs
6
may otherwise be damaged.
Cleaning and care
CAUTION! DANGER OF ELECTRIC SHOCK! First remove
the mains plug
4
from the socket.
CAUTION! DANGER OF ELECTRIC SHOCK! For reasons
of electrical safety the device must never be cleaned with water or
other liquids or immersed in water.
66410_VDE_mel_LED-Lichterkette_Content_LB4.indd 10
12.05.11 11:09