Before first use removing the insulation strips, Operation, Replacing the batteries – Melinera Z30906A/Z30906B/Z30906C User Manual

Page 5: Cleaning and care, Disposal

Advertising
background image

5

GB

result. Never throw batteries into fire or water.
The batteries might explode.

Avoid extreme environmental conditions and

temperatures as they may affect batteries e.g.
above radiators. Otherwise the batteries are
more likely to leak.

Exhausted or damaged batteries can
cause caustic burns upon contact
with the skin. To avoid this, always

wear suitable protective gloves in these circum-
stances!

Avoid contact with the skin, eyes and mucous

membranes if fluid is leaking from a battery. If
you come into contact with corrosive battery
fluids, flush the affected area thoroughly with
clean water and contact a doctor immediately.

Before inserting the batteries, clean the battery

contacts and the contacts of the battery com-
partment using a dry, fluff-free cloth.

Make sure you insert the batteries the right

way round (polarity). The correct polarity is
shown inside the battery compartment.

Remove exhausted batteries from the device

immediately. Otherwise the batteries are more
likely to leak.

Batteries do not belong in household refuse!
Every consumer is obliged to dispose of batteries

properly in accordance with the regulations.

Keep batteries away from children. Do not

throw batteries into a fire. Never short-circuit
them or take them apart.

If you disregard these instructions and advice,

the batteries may discharge beyond their mini-
mum voltage, thus increasing the chance of
leakage. If your batteries leak, remove them
from the device immediately to prevent it from
being damaged.

Always replace all the batteries at once with

batteries of the same type.

Remove the batteries if you are not going to

use the device for an extended period.

The cord of this light set cannot be replaced. If

the cord is damaged the light set should be
scrapped.

The light chain must not be electrically connected

to another light chain.

Before first use

Removing the insulation strips

Note: The device is supplied with the batteries
already in place.

Before first use, pull the battery insulation strips

out from between the batteries and the battery
compartment

2

.

Operation

Press the ON / OFF switch

4

to switch on the

LED-illuminated decoration

1

.

Replacing the batteries

To replace the batteries follow the procedure

described in the figure.

Cleaning and care

Do not use solvents, such as petrol and the like,

as they could damage the device.

Clean the uneven surface with a feather duster

or narrow brush.

Disposal

The packaging is wholly composed of
environmentally friendly materials that can
be disposed of at a local recycling centre.

Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.

Advertising