Melinera Z28957A-BS/Z28957D-BS/Z28957E-BS - Manual (Page 14)

14 GB/MT
Always remove the mains plug from the socket
before installing, dismantling or cleaning.
Never touch the mains plug or the rope light
with wet hands.
CAUTION! RISK OF OVERHEATING! The
lamps in the fairy lights have a power input of
0.455 W each. This wattage not only produces
light, but also heat.
Do not operate the LED rope light
1 in the packaging or when it is
rolled up.
Ensure the rope light is mounted to provide
adequate heat-circulation.
Do not cover the rope light with blankets,
cushions, or similar heat insulating materials.
Use the lighting only with the parts described
in these instructions.
If the rope light is not to be used for any length
of time (e.g. holidays), disconnect it from the
power supply.
After use, keep the rope light in the packaging
to prevent unwanted damage.
Keep away from ponds and other water reser-
voirs. Install the rope light at least 2 metres away
from water containers. Avoid place that might
flood after heavy rainfall.
If using the rope light outdoors, make sure it is
connected to a socket which is protected with
a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30 mA.
The rope light is protected against splashes of
water (IP44) as long as the socket meets the
minimum protection standard.
Make sure the rope light is not laid down in
areas where lawn mowers, trimmers, scissors or
similar cutting tools are used.
Do not pull the light chain cable and make sure
it is laid down properly so that no one walks or
trips over it.
If in any doubt about the safe installation or
use of this product, please consult a qualified
electrician.
Installation safety instructions
Make sure that the product is only installed by
competent persons.
The rope light can be installed on all normally
inflammable surfaces with the enclosed mounting
parts.
CAUTION! RISK OF ELECTRIC SHOCK!
Make sure that there are no power, gas or
water lines located where you wish to drill. Check
with a cable and pipe locator if necessary be-
fore you begin drilling.
Before installation, check whether the surface is
suitable for the mounting parts and the weight
of the rope light. If you are in any doubt, consult
an electrical specialist for advice.
Do not use sharp and / or pointed objects such
as wire, nails or fasteners to mount the rope light.
Do not attach any additional objects to the
rope light.
Avoid excessive bending of the rope light. This
can damage the insulation.
The bending radius of the rope must not fall
below the following value: rope diameter between
10–14 mm: 2 cm.
Avoid excessive heating of the rope light. A
maximum of two sections of rope may cross or
run parallel to each other.
Installation
Note: The rope light 1 can be mounted on all
surfaces officially classified as being of “normal
flammability” by means of the supplied attachments.
Ensure the rope light is mounted to provide ade-
quate heat-circulation. Do not cover the rope light
with blankets, cushions, or similar heat insulating
materials.
Note: You will need a cross-head screwdriver in or-
der to mount the attachment clips
2 and screws 4 .
Use the supplied attachment clips 2 and the
cable ties 3 to install the product.
100624_mel_Lichterschlauch_Content_VDE_ES_IT_PT.indd 14 07.05.14 08:24