Melinera Z30251-BS - Manual (Page 5)

5 GB/IE/CY
Ensure that the product is installed by suitably
experienced or qualified persons only.
CAUTION! RISK OF OVERHEATING! Do
not operate the string lights inside the packag-
ing.
After use, keep the string lights in the packaging
to prevent unwanted damage.
Do not pull the light chain cable and make sure
it is laid down properly so that no one walks or
trips over it.
The product can be used on all surfaces officially
classified as being of “normal flammability“.
Do not attach any other objects to the product.
Avoid the danger of
death from electric shock!
Before use, ensure that the mains voltage
available is the same as the required operating
voltage for the device (230 V∼).
Before connecting the device to the mains you
should always check the string lights and the
mains lead for any damage.
Never use the light set if you discover that it is
damaged in any way.
This light set‘s external flexible tube is non-
replaceable. Hence if it becomes damaged
you must dispose of the entire light set.
This article does not contain any parts which
can be serviced by the user. The bulbs cannot
be replaced.
Only use the string lights with the supplied
power pack for the type (Model No. TH-P2410);
all warranty claims will otherwise expire.
Never open any of the electrical parts or insert
any kind of object into them.
Protect the mains cable from sharp edges,
mechanical loads and hot surfaces.
Do not install with sharp fasteners or nails.
Always unplug the power pack from the socket
before installation, dismantling or cleaning.
Never touch the light chain plug or the light
chain itself with wet hands.
The string lights must not be electrically con-
nected to another set of lights.
If the string lights are not in use for any length
of time (e.g. holidays), disconnect them from
the power supply.
If you have any questions about the product or
are unsure about any of its aspects, please
seek the advice of an electrical equipment
specialist.
This product is intended for use outdoors but
should be plugged into a socket which is located
in an indoor location (e. g. a shed, garage or
porch).
The socket into which this product is plugged
must be protected by a residual current circuit
breaker (RCD) with a trip current not greater
than 30 mA.
Sockets positioned outdoors for use with this
product should be of a type which is adequately
waterproof for an outdoor location and should
be located at least 2.5 m from the nearest body
of water or any location where water may collect.
Use
Note: The bulbs are connected in series. If one
bulb is defective, up to ten bulbs may not light up.
Insert the plug on end of the light set into the
socket of the mains adapter
2 . Please screw
down the connecting nut 3 clockwise.
Insert the mains adapter 2 into the mains
socket.
The light set 1 is switched on.
Pull the mains adapter 2 out of the mains
socket to switch off the light set 1 .
Cleaning and care
CAUTION! DANGER OF ELECTRIC SHOCK!
First pull the mains adapter 2 out of the mains
socket.
CAUTION! DANGER OF ELECTRIC SHOCK!
For reasons of electrical safety the device must
never be cleaned with water or other liquids or
immersed in water.
60306_mel_BS_LED-Lichterkette_content_IE_CY.indd 5 25.03.14 14:56