Melinera Z30171-BS/Z31589-BS - Manual (Page 8)

8 GB/IE
Do not install with sharp fasteners or nails.
Always unplug the mains adapter 3 from the socket before
installation, dismantling or cleaning.
Never touch the light chain plug or the light chain itself with
wet hands.
The string lights must not be electrically connected to another
set of lights.
This product is intended for use outdoors but should be plugged
into a socket which is located in an indoor location (e.g. a shed,
garage or porch).
The socket into which this product is plugged must be protected
by a residual current circuit breaker (RCD) with a trip current not
greater than 30mA.
Sockets positioned outdoors for use with this product should be
of a type which is adequately water proof for an outdoor
location and should be located at least 2.5m from the nearest
body of water or any location where water may collect.
If in any doubt about the safe installation or use of this product,
please consult a qualified electrician.
Use
Note: The light set has 6 parallel wires, each with five small lights
2 and one large light 1 . The distance between the wires is
approx. 16 cm.
Mount the small lights 2 on to the sockets of the bulbs.
Use the supplied suction cups 4 to hang up the light set.
Insert the plug on the end of the light set into the socket of the
mains adapter
3 . Secure the connection by pushing the
100822_mel_LED-Lichtervorhang_Content_BS_GB_IE.indd 8 20.05.14 15:21