Electrolux C65030K - Manual (Page 10)

Operating Instructions
10
Digital displays
The four display fields that are assigned to the four cooking zones dis-
play:
–
j, after being switched on and when the safety function causes an
automatic cut-out,
– = when a cooking zone is selected,
– ! to ), depending on the selected heat setting,
– a during automatic warm up,
– h when there is residual heat,
– f when there is a fault.
1
Cooking Zone Safety Cut-out
If one of the cooking zones is not switched off after a certain time or if
the heat setting is not changed, the corresponding cooking zone
switches itself off automatically.
h appears in the ring display for all rings that are switched on, and j
after they have cooled down.
The rings are switched off at:
3 If one or more cooking zones switch off before the times indicated see
section “What to do if …”.
Cancelling the Safety Cut-out
To cancel the activated safety cut-out the appliance must be switched
off and then on again using the ON/OFF
n
sensor
field. After this the
cooking zones are again ready for use.
Switching Off for Other Reasons
Liquids that boil over onto the control panel cause all cooking zones to
switch off immediately.
If you place a wet cloth on the control panel it has the same effect. In
both cases the appliance has to be switched on again using the mains
switch
n
after removing the liquid or cloth.
• Heat setting 1 - 2 after 6 hours
• Heat setting 3 - 4 after 5 hours
• Heat setting 5 after 4 hours
• Heat setting 6 - 9 after 1.5 hours