Emerson CF730 - Manual (Page 11)

NOTE: Retrofit 3-way installations are
likely to include two traveler wires
between the two wall boxes. In new
construction, only one traveler wire Is
required.
3-WAY WIRlNG DIAGRAM:
NEW CONSTRUCTION
6. Place wall control into wall box. Screw
in place and install decorator style
faceplate (included).
7. Next, install the other wall control into
the wall box containing the load wire.
Connect the black wire of the wall
control to the traveler wire(s) already
connected to the black wire (in the
other wall box). Secure with wire
connectors supplied.
11
HOT
BLACK
FAN/LIGHT
WALL
CONTROL
TRAVELER
WIRE
BLK BLK LOAD
BLACK
GROUND NEUTRAL
EMERSON ® EMERSON ®
HI
MED
LOW
FAN OFF
LIGHT
ON OFF
HI
MED
LOW
FAN OFF
LIGHT
ON OFF
REMOTE CONTROL
RECEIVER LOCATED
UNDER THE FAN
HOUSING
Figure 17
HOT BLK
FAN/LIGHT
WALL CONTROL
BLK
TRAVELER WIRES
BLK
BLK
BLACK
LOAD
BLACK
LOAD TRAVELER WIRES
HOT BLK
EXISTING
WALL CONTROL
EMERSON ® EMERSON ®
HI
MED
LOW
FAN OFF
LIGHT
ON OFF
HI
MED
LOW
FAN OFF
LIGHT
ON OFF
Figure 18
STANDARD WIRING FOR EXISTING
3-WAY CONTROL
8. Connect one black wire of the wall
control to the “load” (black) wire and
secure with wire connector supplied.
9. Place the second wall control into the
wall box. Screw in place and install
decorator style faceplate (included).
Leave switch in “OFF” mode until fan
installation is completed.
10. Refer to page 4 and complete the
ceiling fan installation.
BP7315 Florissant 3/7/06 8:42 AM Page 11