Sealey VSE127H05 User Manual
Fig.1 fig.2
INSTRUCTIONS FOR:
Ball Joint Removal/Installation Set
(Mercedes Sprinter)
Model No:
VSE127H05
1.
SAFETY INSTRUCTIONS
2.
INTRODUCTION & SpECIFICATION
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE TOOL CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
WARNING! Ensure Health and Safety, local authority and general
workshop practice regulations are adhered to when using tools.
DO NOT use tools if damaged.
Maintain tools in good and clean condition for best and safest
performance.
Ensure that a vehicle which has been jacked up is adequately
supported with axle stands and that the wheels are chocked.
Ensure that the rear axle is adequately supported, refer to the
vehicle manufacturer’s service instructions, or a proprietary
manual.
Wear approved eye protection. A full range of personal safety
equipment is available from your Sealey dealer.
Wear suitable clothing to avoid snagging. Do not wear jewellery
and tie back long hair.
DO NOT use air tools to operate the force screw.
IMPORTANT: The force screw must be kept well lubricated.
IMPORTANT: This manual is provided as a guide only, refer to
the vehicle manufacturer’s service instructions, or a proprietary
manual, to establish the current procedure and data.
WARNING! Failure to heed safety and warning instructions may
result in damage and/or personal injury and will invalidate the
warranty.
WARNING! The warnings, cautions & instructions referred
to in this manual cannot cover all possible conditions and
situations that may occur. It must be understood that
common sense and caution are factors which cannot be
built into this product, but must be applied by the operator.
Use in conjunction with Sealey Hydraulic Ball Joint Remover/Installer
Kit (Model No. VSE127H). Essential tool for removal/installation of the
Mercedes Sprinter front lower ball joint in situ. Includes all necessary
adaptors.
SpECIFICATION:
Model No. ....................................................................... VSE127H05
Model No. of associated Tool .............................................. VSE127H
Ball joint OE Number ....................................................... 9013330727
Application - Mercedes ............... Sprinter 901, 902, 903, 904 (95-on)
3.
OpERATION
NOTE! Pictures taken with the lower arm / wishbone removed from
vehicle for clarity only.
NOTE! Before installing the new ball joint, refer to the vehicle
manufacturer’s service instructions, or a proprietary manual, to
establish the correct data and procedures.
VSE127H05 Issue No. 1 - 10/11/09
ALWAYS KEEp FORCE SCREW
WELL LUBRICATED.
DO NOT USE AIR TOOLS
Original Language Version
Fig.1
Fig.2