Elo TouchSystems ET1X45C-4SWE-1 - Manual (Page 11)

2-7
Attach the Back Cover
• When you have finished connecting your touchmonitor, bring the three cords
together at the back of the monitor.
• Place the back cover on the back and pull the cords through the cut out of the
back cover.
• Replace the four screws and tighten them securely. Be sure not to over
tighten the screws.
• Your touchmonitor has no power switch. Power on your monitor using the
power switch of the surge protector, and check that the power LED is on. If
not, refer to Chapter 4, Troubleshooting.
• After a brief pause the picture should appear. If necessary, adjust the front
panel controls according to your personal preference (see Chapter 3).
• Insert the Elo TouchTools CD-ROM in your computer’s CD-ROM drive to
install the appropriate touchscreen driver software. Follow the directions
starting on the next page to install the driver software.
Note: If this monitor is intended to be used in an existing system, the driver software may
already be installed by the system manufacturer. Skip to Chapter 3.