Euro-Pro EP187 - Manual (Page 7)

PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
HAND VACUUM
WILL NOT
OPERATE
1. Power cord not firmly
plugged into outlet.
2. No power in wall outlet.
3. Needs servicing.
4. Thermostat has tripped.
1. Plug unit in firmly.
2. Check fuse or breaker.
Replace fuse/reset breaker.
3. Call 1 (800) 798-7398.
4. Turn the unit off and unplug
from outlet. Allow unit to cool
down, then restart
HAND VACUUM
WILL NOT PICK-UP
OR SUCTION
POWER IS WEAK
1. Dust cup is full.
2. Unit clogged.
3. HEPA dust cup filter
needs cleaning or
replacing.
4. Hose clogged
1. Empty dust cup
2. Turn unit off and unplug from
wall outlet. Remove HEPA dust
cup filter and check for object(s)
in air duct and remove.
3. Clean or replace HEPA dust cup
filter.
4. Turn unit off and unplug from
wall outlet. Check for objects in
hose
TURBO BRUSH
DOES NOT
ROTATE OR
ROTATES
SLOWLY
1. Rotating brush or elbow
obstructed.
2. Belt broken.
3. Hose obstructed.
4. HEPA dust cup filter
clogged.
1. Clear obstructions.
2. Call 1 (800) 798-7398.
3. Clear obstruction.
4. Clean HEPA dust cup filter.
DUST ESCAPING
FROM HAND
VACUUM
1. Dust cup is full.
2. HEPA Dust Cup Filter is
not installed correctly.
3. There is a puncture/hole
in HEPA Dust Cup Filter.
1. Empty dust cup.
2. Review HEPA Dust Cup Filter
instructions.
3. Replace HEPA dust cup filter.
HAND VACUUM
HOSE OR
BRUSHES WILL
NOT PICK-UP
1. Hose clogged.
2. Dust cup is full.
1. Remove hose and/or bushes.
Remove obstruction from hose.
2. Empty and clean dust cup.
TROUBLESHOOTING GUIDE
Important: This unit is equipped with
a motor protective thermostat. If for
some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of overheating
problem. (i.e. clogged hose or
filter)
Motor Thermostat • If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact customer service at
1 (800) 798-7398.
FAMILIARISEZ-VOUS AVEC VOTRE RETRACTEUR
SHARK
OPERATING INSTRUCTIONS
1. Bouton de relâche
de la coupelle
2. Bouton de mise en marche
3. Coupelle à poussière (réservoir)
4. Trappe de succion
5. Bouton Rétracteur
6. Poignée
7. Suceur plat
8. Brosse à épousseter
9. Électrobrosse pneumatique
10. Boyau souple
11. Bandoulière
12. Écran à débris
13. Filtre HEPA
14. Sac de rangement (non illustré)
Spécifications techniques
Tension : 120 V, 60 Hz
Intensité : 7.1 A
Avertissement : Les illustrations peuvent différer du produit lui-même.
16 5