Sealey MS025 - Manual (Page 2)

fig.3 - Press fitting link plate fig.4 - Riveting pins
fig.5 fig.6
3.2. Press fitting link plate.
3.2.1. connect the two ends of the chain with a new connecting link.
Note: Ensure that o rings are correctly positioned between the
plates, and that the plates are adequately lubricated - see
manufacturer's instructions (fig.5).
3.2.2. Position the u holder over the link so that the end of the plate's pins
fit into the 2 recesses (fig.3.2).
3.2.3. fit a suitably sized pin into the pin holder and position the plate
holder over the end of the pin (fig.3.3).
3.2.4. Slide the pin holder body onto the u holder and tighten the securing
screw in position A (fig.3.4).
3.2.5. Screw in the pin holder so that the plate holder is in contact with
the new link (fig.3.5).
3.2.6. use a 27mm spanner to hold the pin holder body and a 19mm
spanner to turn the pin holder. Turn the pin holder clockwise and
proceed to start push fitting the link plate onto the pins (fig.3.6).
Back off the pin holder and remove the plate holder, then follow the
instructions for riveting in 3.3.
3.3. Riveting pins.
3.3.1. Loosen securing screw and reposition the pin holder body on the
u holder in position B and retighten the securing screw (fig.4.3).
3.3.2. Screw in the pin holder, ensuring that the riveting pin is positioned
centrally onto one of the pin heads (fig.4.1).
3.3.3. use a 27mm spanner to hold the pin holder body and a 19mm
spanner to turn the pin holder. Turn the pin holder clockwise and
start to push the riveting pin onto the pin. Keep checking to ensure
that the riveting pin is centrally located on the pin and that it is
cleanly riveting it.
3.3.4. The rivet should be clean, centred and deep enough, see fig.6.
3.3.5. When the first pin has been riveted, undo the pin holder, re-position
the chain so that the other pin is lined up with the riveting pin and
repeat the above procedure in 3.3.3.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7Ar
www.sealey.co.uk
Web
email
Original Language Version MS025 Issue: 1 - 02/11/10
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or phone 01284 757500.