Sealey MPS3 - Manual (Page 2)

NOTE: The stand needs to be used in conjunction with suitable external motocycle support to ensure full stability.
Although the support stand can be operated by one person, we advise seeking the assistance of a second person. A concrete
deck working area is recommended (tarmacadum may crumble).
4.1. Setting to the correct height.
4.1.1. Ascertain the required lift height by measurement (fig.4). Adjust lift height tubes and lock in place by fitting M8 screws as described
in 3.1.2.
4.1.2. Slide the handle with or without extension into fulcrum frame as described in 3.1.4.
4.2. Support stand placement (fig.3).
4.2.1. With the handle vertical (fig.4), slide the fulcrum support frame beneath the point to be lifted. Choose a point with mechanical integrity.
4.2.2. Check the path of the load bearing support bar will not crush or deform cables, pipes, exhaust or panels.
4.2.3 With external support options available, slowly raise the motorcycle wheel off the concrete deck using the handle (fig.5).
4.2.4 As the handle approaches the ground, a sweep of approximately 90°, take care not to let go of it. The weight of the motorcycle will now
be pushing down (gravity) on the handle in the last 15° of total sweep angle.
4.2.5 Remove the handle to avoid tripping danger whilst servicing.
4.2.6 Check that the motorcycle is stable on the stand and suitably supported before leaving it.
4.3. Removing the stand.
4.3.1 Slide the handle with or without extension into fulcrum frame as described in 3.1.4.
4.3.2. Slowly and smoothly lift the handle of the stand upwards, ensuring that the mototrcycle remains stable at all times. Continue to lift the
stand handle until all the weight of the motorcycle is taken by the concrete deck.
4.3.3 Slide the stand away from beneath the motorcycle.
5.1. Before each use, check all parts. If any part of the stand is damaged or defective, remove it from service and take the
necessary action to remedy the problem.
5.2. Keep the stand clean and wipe off any oil or grease.
5.3. When the stand is not in use, store it in a safe, dry, childproof location.
5. MAINTENANCE
4. OpERATING INSTRUCTIONS
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version MPS3 Issue: 1 - 06/02/13 © Jack Sealey Limited 2013
180
250
Slide under motorcycle
Raise motorcycle, remove
handle to avoid tripping danger
Environmental protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
Stand with handle removed
To lower
To raise
fig.3
fig.4
fig.5