Sealey MS063 - Manual (Page 2)

Original Language Version
Ms063 Issue: 1 - 27/07/12
3.1. Assembly
unpack the dolly and check contents with list above. should there be any damaged or missing parts contact your supplier
immediately. numbers in brackets refer to item numbers in fig.1.
3.1.1. Attach the castors (2) to the frame assembly (1) and the platform (17) using M6 x 16 bolts (3), flat washers Ø6 (4), lock washers Ø6
(5) and nut M6 (6).
3.1.2. connect the frame assemblies (1) with the connecting bars (16) using M8 x 55 bolts (11), flat washers Ø8 (12), lock washers Ø8 and
nuts M8 (14).
3.1.3. fit the platform (17) using screws M8 (15), flat washers Ø8 (12), lock washers Ø8 (13) and nuts M8 (14). the frame assemblies (1)
have six holes for fitting the platform (17) in various positions to suit the particular motorcycle side stand position.
3.1.4 fit the connecting plates (7) to the wedge gates (9) and (18). Attach the connecting plates (7) to the frame assemblies (1) using
screws M6 (8), flat washers Ø6 (4), lock washers Ø6 (5) and nuts M6 (6).
3.1.5. Insert the stop pins (10) in to the slots in the frame assembly (1).
3.1.6. check that all fasteners are fully tightened.
Item Description Qty Item Description Qty
1 frame Assembly 2 10 stop Pin 2
2 castor 5 11 Bolt M8 x 55 8
3 Bolt M6 x 16 20 12 flat Washer Ø8 10
4 flat Washer Ø6 28 13 Lock Washer Ø8 10
5 Lock Washer Ø6 28 14 nut M8 10
6 nut M6 28 15 screw M8 2
7 connecting Plate 4 16 connecting Bar 2
8 screw M6 8 17 Platform 1
9 Wedge Gate 'A' 1 18 Wedge Gate 'B' 1
3. ASSEMBLY
4. OPERATION
 WARNING! Ensure that you read, understand and apply the safety instructions before use.
 WARNING! DO NOT attempt to overload the dolly.
4.1. Loading
4.1.1 Position the dolly in a suitable area, checking that the surface on which the dolly will be used is solid and flat (preferably concrete).
4.1.2 Lower the wedge gates (9) and (18) to hold the dolly in position.
4.1.3 remove the stop pin (10) from the frame assembly (1) at the end of the dolly the motorcycle is to be loaded.
4.1.4 Push the motorcycle on to the dolly and support with the side stand on the platform (17) and replace the stop pin (10).
4.1.5. secure the motorcycle using suitable straps.
4.1.6. Lift the wedge gates (9) and (18) to allow the dolly to be manoeuvred.
fig.1
© Jack sealey Limited 2012