Fig.3 fig.4 fig.5 fig.2 – Sealey MS065 User Manual
Page 2
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Original Language Version
MS065/66/67 Issue: 1 - 18/07/12
© Jack Sealey Limited
Fig.3
Fig.4
Fig.5
Fig.2
3.3.
Fitting the Cover (fig.2).
3.3.1. Fit the cover with the frame in the open
position.
3.3.2. Insert tubes (E) into 2 side sleeves and
last connector (C) into the middle sleeve
at one end of the cover and then push fit
connector (C) into the ends of the tubes (E).
3.3.3. Pull cover over the rest of the frame and secure
other end to connector (D) by wrapping the flap
around it and securing it with touch fastener.
3.3.4. Lift connector (C) at the other end and enter
under the cover. Move each rib into position
and secure to the cover by wrapping the flaps
around them and securing with touch fasteners
until all the ribs are connected except the first
one connected to the H tubes - this is not
secured to the cover.
3.4.
Securing the Frame.
3.4.1. It is recommended that the frame is secured to
the ground using weights or bolted down as
appropriate. Secure using pre-drilled holes in
frames A and B and at connector D.
3.5.
Use.
3.5.1. To use the shelter, simply open it (fig.3) and
then manoeuvre the motorcycle into the shelter.
If engine and exhausts are hot - ensure that
they do not come into contact with the cover.
Ensure motorcycle is correctly supported
before leaving it (fig.4). Pull cover over the
motorcycle and engage lock tube over lock bar,
and secure with a padlock (not supplied) if
required (fig.5).
3.6.
Folding Down.
3.6.1. If the Shelter needs to be folded down for
removal, undo any bolts securing the frame to
the ground, then undo the nuts and bolts
securing the tubes (H) to the tubes (G) and ribs.
Remove tubes (H) and collapse the shelter.