Vitek VT-7123 ST - Manual (Page 4)

ENGLISH
4
• If the unit is dropped into water:
– do not touch the water;
– unplug the unit immediately,
only after that you may take
the unit out of water;
– apply to the authorized ser-
vice center for testing or
repairing the unit.
•
Do not allow children to touch
the coffee grinder body and the
power cord during the unit oper-
ation.
•
Do not leave children unattended
to prevent using the unit as a toy.
• During the unit operation and
breaks
between operation
cycles, place the unit out of
reach of children.
• The unit is not intended for
usage by physically or mental-
ly disabled persons (including
children) or by persons lacking
experience or knowledge if they
are not under supervision of a
person who is responsible for
their safety or if they are not
instructed by this person on the
usage of the unit.
• For children safety reasons do not
leave polyethylene bags used as a
packaging unattended.
ATTENTION! Do not allow children
to play with polyethylene bags or
packaging film. Danger of suffo-
cation!
•
Check the power cord and plug
periodically. Do not use the cof-
fee grinder if the unit, the power
plug or the power cord is dam-
aged.
• Do not attempt to repair the unit.
Do not disassemble the unit by
yourself, if any malfunction is
detected or after it was dropped,
unplug the unit and apply to any
authorized service center from
the contact address list given in
the warranty certificate and on
the website www.vitek.ru.
• To avoid damages, transport the
unit in the original package only.
• Keep the unit out of reach of chil-
dren and disabled persons.
THE UNIT IS INTENDED FOR
HOUSEHOLD USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or stor-
age at low temperature keep it
for at least three hours at room
temperature before switching on.
– Unpack the coffee grinder com-
pletely and remove any stickers
that can prevent its operation.
– Check the unit for damages; do
not use it in case of damages.
– Before switching the unit on,
make sure that your home mains
voltage corresponds to the unit
operating voltage.
– Unwind the power cord com-
pletely.
– Remove the lid (3), for this rotate
it counterclockwise.
– Wash the lid (3) with warm water
and a neutral detergent and dry
it thoroughly.
– Clean the process chamber (2),
the knives and the body (1) with
IM VT-7123.indd 4 16.06.2016 15:10:09