Epson 5000 - Manual (Page 71)

Tear Off
Adjusting the tear-off position
If the perforation is not aligned with the tear-off edge, adjust the
tear-off position by following the steps below:
1.
2.
3.
4.
Make sure the paper is in the tear-off position and the
TEAR OFF
light is on.
While holding down the
ALT
button, press the
LOAD/EJECT
button to adjust the tear-off position to a lower position on the
page or press the LF/FF button to adjust the tear-off position to a
higher position on the page. The printer remembers the new
tear-off position.
Tear off any printed pages.
When you begin printing, the printer automatically feeds the
paper back to the loading position and begins printing. (You can
also manually feed the paper back to the loading position by
pressing the
LOAD/EJECT or TEAR OFF button.)
Note:
l
The printer has a minimum and maximum tear-off position. If
you try to advance the loading position beyond these limits,
the printer beeps and the paper stops moving.
l
When the paper reaches the factory-set tear-off position, the
printer beeps and paper feeding pauses briefly. Use the factory
setting as a reference point when adjusting the tear-off
position.
3-18 Using the Printer