Elta 6696 User Manual

Page 15

Advertising
background image

MAINTENANCE & SAFETY

PRECAUTIONS & GENERAL MAINTENANCE
•

Place the set on a hard and flat surface so the system does not tilt.

•

Do not expose the set, batteries or CD to humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.

•

Do not cover the set. Adequate ventilation with a minimum gap of 15 cm between the
ventilation holes and surrounding surfaces is necessary to prevent heat build-up.

•

The mechanical parts of the set contain selflubricating bearings and must not be oiled or
lubricated.

•

To clean the set use a soft dry cloth. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the housing.

CD PLAYER AND CD HANDLING
•

The lens of the CD player should never be touched!

•

Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud
over. Playing a CD us then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the
moisture evaporates.

•

Always close the CD door to keep the CD Compartment dust-free. To
clean, dust the compartment with a soft dry cloth.

•

To clean the CD, wipe in a straight lien from the center towards the edge
using a soft, line-free cloth. Do not use cleaning agents as they may
damage the disc.

•

Never write on a CD or attach any stickers on it.

TROUBLESHOOTING

TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.

WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
-

Problem

•

Solution

NO SOUND/POWER
-

Volume not adjusted

•

Adjust the volume

-

Power cord not securely connected

•

Connect the AC power cord properly

-

Batteries dead/incorrectly inserted

•

Insert (fresh) batteries correctly

DISPLAY DOES NOT FUNCTION PROPERLY / NO REACTION TO OPERATION OF ANY THE CONTROL
-

Electrostatic discharge

•

Switch off and unplug the set. Reconnect after a few seconds

15.

02-6696-GB 9/12/06 9:17 AM Page 15

Advertising