Silvercrest SKE 6 A1 - Manual (Page 7)

4 SKE 6 A1
GB
Inserting/replacing batteries
ATTENTION! MATERIAL DAMAGE!
► When inserting the batteries, observe the
polarity indicated on the battery compart-
ment cover!
► Always use Mignon AA, LR6 batteries.
► Always use batteries of the same type.
1) Remove the decorative cap 1 by turning it so
that the arrow on the decorative cap 1 points
towards the marking "Open". Remove the
decorative cap 1.
2) Open the battery compartment 2 by pulling
the catch 3 towards you and unlatching the
battery compartment 2.
3) Remove the old batteries, if present.
4) Insert the new batteries as per the polarity
diagram provided on the cover of the battery
compartment.
5) Close the battery compartment 2 so that the
catch 3 clicks into place.
6) Replace the decorative cap 1 so that the arrow
on the decorative cap 1 points towards the
marking "Open". Turn the decorative cap 1
so that the arrow points to the marking "Close".
The decorative cap 1 is now fi rmly back in
place on the appliance.
Handling
NOTE
► Do not attempt to remove champagne corks
with the corkscrew! These can get caught in
the appliance.
Figure 1
1) Use the foil cutter 6 to cut open the foil sleeve
encasing the bottle cork:
Place the foil cutter 6 onto the closed bottle of
wine as shown in Figure 2.
2) Press it together fi rmly with your thumb and
forefi nger. Grip the bottle fi rmly with one hand
so that it cannot fall over.
Figure 2
3) Turn the bottle of wine through 360 degrees.
You may have to repeat this several times
before you can remove the foil sleeve capsule.
✕
✓
IB_100655_SKE6A1_LB4.indb 4 IB_100655_SKE6A1_LB4.indb 4 04.06.14 14:40 04.06.14 14:40