Silvercrest Foot Warmer - Manual (Page 5)

9 GB
Use / Cleaning and care
Use
Note: The foot warmer may give off an odour of
plastic on first use. This odour will cease to develop
after a short while.
Switching on / off / Selecting
the temperature
Insert the mains plug into the mains socket.
Switching on:
Set the control unit 2 to setting 1, 2, 3, 4, 5
or 6 to switch on the foot warmer.
Note: The function indicator 3 illuminates after
the foot warmer is switched on.
Note: This foot warmer has a rapid heat-up
feature, which will cause the foot warmer to
warm up quickly within the first 15 minutes.
Switching off:
Set the control unit 2 to setting 0 to switch off
the foot warmer.
Note: The function indicator 3 ceases to illuminate.
Selecting the temperature:
Just before using the foot warmer, set it to the
highest temperature setting (setting 6). This will
cause the foot warmer to warm up quickly.
If you are going to use the foot warmer for a
number of hours, set it to the lowest temperature
setting (setting 1).
The foot warmer can, of course, also be used at
any time if it is switched off. Its fur-fabric luxury
is warm in the event that a convenient electrical
socket is not available.
Temperature settings
Using the control unit 2 set the temperature to
the desired temperature setting.
Setting 0: Off
Setting 1: Minimum heat
Settings 2 – 5: Customised heat
Setting 6:
Maximum heat
Automatic switch-off
Note: The foot warmer switches itself off automati-
cally after about 90 minutes. The function indicator
3
then starts to flash.
Then select the setting 0 and after about 5
seconds, reset the foot warmer to the desired
temperature setting to switch it on again.
Switch the foot warmer off (setting 0) and pull
the mains plug out of the mains socket if the
foot warmer is not to be used after it has
switched itself off automatically.
Cleaning and care
Keep the foot warmer clean as it cannot be
washed.
RISK TO LIFE
FROM ELECTRIC SHOCK! Before
cleaning the foot warmer always
remove the plug from the mains socket.
Small stains can be removed with a cloth or
moist sponge and if necessary with a little mild
detergent. The foot warmer must not become
soaked through when doing this.
Please note that the foot warmer must not be
machine-washed, spun or dried, chemically
cleaned, wrung out, put through a mangle or
ironed.
The removable fur-fabric lining 1 can be
washed by hand.
RISK OF ELECTRIC SHOCK!
RISK OF DAMAGE TO THE
PRODUCT! Use the foot warmer
again only after the foot warmer and the fur-fabric
liner
1 are completely dry.
67225_silv_Fußwaermer_Content_LB4.indd 9 04.05.11 10:11