Silvercrest SLUB 85 A1 - Manual (Page 9)

9 GB
Important safety instructions / Safety system / Preparing for use
· do not switch the electric under-
blanket on if it is folded or drawn
together,
· do not wrap up in the electric underblanket
in bed and do not wrap it around the mattress,
· ensure that the electric underblanket and the
cables do not become trapped, particularly
in adjustable beds or dividable mattresses,
· do not sharply bend the electric underblanket,
· do not place any object, such as a case or a
washing basket on the electric underblanket
while it is switched on,
· do not place any source of heat, such as a
hot-water bottle or the like on the electric
underblanket while it is switched on.
Otherwise the electric underblanket could be
damaged.
Do not cover the control unit 1 and do not
place it on the electric underblanket when it is
in use. The electronic components in the control
unit
1 of the electric underblanket cause the
control unit 1 to heat up slightly during opera-
tion.
Safety system
Note: The electric underblanket is fitted with a
safety system. Its electronic sensor system prevents
the electric underblanket from overheating over its
full area by switching it off automatically in the event
of a fault. If the safety system switches the electric
underblanket off automatically due to a fault, then
the display
2 on the control unit 1 ceases to
illuminate, even if the electric underblanket is
switched on.
Please note that, for safety reasons, the electric
underblanket must not be used in the event of a
fault and must be sent to the service centre
address given below.
Preparing for use
Placing the electric
underblanket
Starting at the foot end, spread out the electric
underblanket over the mattress so that the plug-
in connector
7 is approximately at the level of
the shoulders (see fig. B).
Note: The head area is not heated.
Guide the mains plug of the plug-in connector
7 through the slot in the side part 8 and then
connect the control unit 1 to the electric un-
derblanket by plugging the two parts of the
plug-in connector
7 together (see fig. B and C).
Then pull the side part as you would a fitted
sheet over the sides of your mattress. The elec-
tric underblanket is designed so that it fits 90 x
200 cm as well as 100 x 200 cm mattresses.
Then place the bottom sheet as usual over the
electric underblanket, so that the electric under-
blanket lies between the mattress and the bottom
sheet.
Ensure that the electric underblanket is com-
pletely flat and that it does not become drawn
together or folded during use.
Switching on / off
Switching on:
Press the ON /OFF switch 4 on the control
unit 1 , to switch on the electric underblanket.
When switched on, the display 2 illuminates
and shows all its segments for approx. 3 seconds.
Afterwards the display 2 indicates the follow-
ing basic settings: Temperature range for the
body zone: 0 automatic switch-off time: 1h
(= 1 hour) temperature range for the foot
zone: 0
Switching off:
Press the ON / OFF switch 4 on the control
unit 1 to switch off the electric underblanket.
When switched off, the light and the display 2
cease to illuminate.