Earlex HV2900 - Manual (Page 6)

CAUSE ACTION REQUIRED
Paint too diluted Add undiluted paint
Paint output too high Reduce the paint output by adjusting the Paint Flow Adjuster (9)
Moving too slowly Increase speed of application
Spray Trigger held for too long Release Trigger sooner
Spray Gun too close Increase the distance between the Spray Gun and the work
surface
Paint too diluted Add undiluted paint
Paint output too low Increase the paint output by adjusting the Paint Flow Adjuster (9)
Moving too fast Reduce speed of application
Spray Gun clogged Clean the Spray Gun
Spray Gun too far away Move the Spray Gun closer to the work surface
Paint too thick Add thinner
Fluid Tip clogged Clean the Fluid Tip (5)
Pick-up Tube clogged Clean Pick-up Tube (11)
Air Hose split Replace air Hose (13)
Grainy paint Filter the paint
Paint Container almost empty Refill Paint Container (12)
Spray Gun at an angle Check that the Pick-up Tube (11) is pointing towards the paint
Air inlet blocked Check the condition of the Filter (14) and clean if necessary
You move your wrist Move your forearm instead
Either too much or not enough paint Use the Paint Flow Adjuster (9) to control the flow
PROBLEM
The paint drips onto item being
painted
Paint is too thin or irregular
No paint being released
Too much paint in an area
Application
TROUBLESHOOTING
S
P
R
A
Y
G
U
N
6