Silvercrest CRB-631 - Manual (Page 15)

Installation - CRB-631
15
En
g
lish 5) Connect the ISO connectors A and B to the corresponding connections of the
radio.
6) Push the radio into the installation frame until it clicks into place (Fig. 1).
7) Then finish installation by placing the front trim frame onto the front of the car
radio (Fig. 1).
Note:

Only fit the operating panel when the car radio has been fully fitted. The
operating panel could otherwise be damaged when you push the car radio into
the slot when the panel is already fitted.
 Steps 8 and 9 are only possible when the rear of the radio is accessible inside
the dashboard or console.
8) Push the assembly rail (perforated metal strip) onto the M5 bolt and secure it
with the M5 nut (Fig. 2).
9) Secure the other end of the assembly rail to the vehicle bodywork with a
Bt5x16 screw (Fig. 2).
9.3 Removing the device
Fig. 3
To remove the device CAREFULLY remove the trim frame from the radio (without
using force, as the connecting pins could snap). Then insert both removal tools on the
left and right of the radio until they engage. Then carefully remove the device from the
dashboard.