Silvercrest SDS 3000 A1 - Manual (Page 9)

7 SDS 3000 A1
GB
Should you wish to bring the tripod plate ■ 3 through up to 90°, from the
vertical to the horizontal position, to take for example photos in portrait
format, then loosen the tripod head screw 9. Swivel the tripod plate 3 into
the required position and then retighten the tripod plate screw 9 fi rmly.
NOTICE
You can additionally stabilise the tripod by placing a weight (max. 2 kg) ►
on the accessory hook t.
Transportation and storage
Transport the tripod by using the transport handle ■ z. This is also possible
when it is set up.
If you need to transport the tripod over long distances, then slide it together ■
and place it into the supplied transport bag.
Store the tripod at a clean and dry location. Preferably, in the supplied ■
transport bag.
Cleaning and Care
WARNING - PROPERTY DAMAGE!
Do not use abrasive or aggressive cleaning materials. These could attack ►
the upper surfaces and irreparably damage the tripod.
Clean the tripod with a lightly moistened cloth.. For stubborn soiling use a ■
mild detergent on the cloth..
Disposal of the device
Dispose of the appliance through an approved disposal centre or at your com-
munity waste facility. Observe the currently applicable regulations. In case of
doubt, please contact your waste disposal centre.
Technical data
Max. loading approx. 3 kg
Height when compacted approx. 55. 5 cm
Height when fully extended approx. 157 cm
Thread size 6,35 mm / 1/4 inch
IB_71271_SDS3000A1_LB4.indb Abs3:7 IB_71271_SDS3000A1_LB4.indb Abs3:7 12.10.2011 9:31:37 Uhr 12.10.2011 9:31:37 Uhr