Unpacking and setting up – Silvercrest SZW 400 A1 User Manual

Page 47

Advertising
background image

SZW 400 A1

45

•Should some sugar fall nonetheless

into the bottom section 9, proceed as
described in “8. Faults and remedies”
on page 48.

5. Unpacking and setting up

Note: As the appliance and heating
elements 5 are supplied with a thin film of
grease, there might be a small amount of
smoke and odour the first time the appliance
is used. This is not harmful and will stop after
a short while. Please ensure meanwhile that
there is sufficient ventilation.
1. Remove the individual parts from the

packaging.

2. Check that all the individual parts are

complete (see “1.2 Scope of supply” on
page 40) and there are no signs of
damage.

3. Clean the appliance thoroughly before

using it for the first time (see
“7. Cleaning” on page 47).

4. Place the candyfloss bowl 6 on the

bottom section 9.

5. Turn the candyfloss bowl 6

anticlockwise so that the candyfloss
bowl engages in the locks 7.

6. Position the carameliser 2 on the drive

shaft 4.
Note: There is a cross pin located in
the drive shaft 4. This cross pin must grip
into the lower indentation on the
carameliser 2.

7. Position the splash guard 1 onto the

candyfloss bowl 6.

8. Place the appliance on a level, dry, non-

slip surface, so that the appliance can
neither topple over nor slide down.

7

4

RP75819 ZuckerWG LB5 Seite 45 Dienstag, 24. Juli 2012 9:58 09

Advertising