Silvercrest SWKG 3000 A1 - Manual (Page 25)

- 23 -
Removing the lid
To make the cleaning of the appliance interior easier,
you can remove the lid
w :
• Open the lid w .
• Press the lid w , as shown in the diagramme, to
the rear q .
• You can then pull out the hinge and lift out the
lid w , as shown in the diagramme w .
• On reassembly, ensure that the lid w is put in
the correct way round. The thickening at the frame
of the lid
w must point upwards when it is being
replaced, and also the level surface of the frame
to the handle
r . Otherwise, the lid w cannot
be closed!
w
q
Removing/replacing the pouring sieve
• Open the lid w .
• Pull the pourer sieve q upwards out of its holder.
• Clean the pouring sieve q with a lightly moistened
dishcloth and under running water.
• After cleaning, insert the pouring sieve q from
above and press it firmly into place. Ensure that
the bar on the pourer sieve
q is gripped in the
guide rail.
• Should the scale deposits in the pourer sieve q
be firmly settled, lay it in a water-vinegar solution,
with a ratio of 6:1, for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
sieve
q with lots of clear water.
Storage
Allow the appliance to cool off completely before
putting it into storage.
• Wind the power cable
u around the holder on
the bottom of the appliance.
• Store the appliance in a dry place.
IB_75768_SWKG3000A1_LB2 18.06.2012 9:45 Uhr Seite 23