Silvercrest SKT 2300 A1 - Manual (Page 41)

SKT 2300 A1 39
2. Plug the mains plug into a wall socket
that complies with the technical data.
Note:
If you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
4.3 Inserting the batteries
If the appliance is new or the batteries in the
remote control are flat, new type AAA/R03
batteries must be inserted.
1. Press the catch
and lift the lid off
the battery com-
partment.
2. Remove the old batteries if present.
Note: Please observe the instructions for
disposal (see “8.2 Disposable/recharge-
able batteries” on page 42).
3. Insert new batteries.
Note: Ensure the correct polarity (+/–).
The correct polarity is shown on the bot-
tom of the battery compartment.
4. Close the battery compartment again.
5. Operating
5.1 Using the appliance for the first
time
1. Plug the mains plug into a wall socket
that complies with the technical data (see
“9. Technical data” on page 43).
2. Switch the mains switch 8 to ON to
switch on the power supply.
The lamp in the main switch 8 lights up
and you hear a beep.
3. Press the On/Off button 18 to switch the
appliance on.
The display 9 lights up.
The appliance is now ready for use and can
be operated by means of the remote control
or control panel 2. To operate the appliance
by means of the control panel 2, first raise
the cover 3.
5.2 Selecting the temperature
1. To choose whether you wish the tempe-
rature to be displayed in °C or °F, press
button 13.
The indicator light 12 shows which unit
of measurement is selected.
2. Press the “Increase temperature” button
21 to increase the desired temperature
up to a maximum of 35 °C (95 °F).
The selected desired temperature flashes
in the display 9.
3. Press the “Reduce temperature” button
20 to lower the desired temperature to a
minimum of 10 °C (50 °F).
The selected desired temperature flashes
in the display 9.
RP66642 Konvektor LB5 Seite 39 Donnerstag, 19. Mai 2011 10:54 10