Silvercrest SNHT 1.5 B2 - Manual (Page 45)

43 SNHT 1.5 B2
GB
MT
Close the battery compartment 3) 5. To do this, place the battery
compartment cover 6 at an angle on the battery compartment 5,
so that the spot on the battery compartment cover 6 lies under
the opened lock on the hand element 4
. Turn the battery
compartment cover 6 until the spot lies under the closed lock on
the hand element
.
Using the appliance
Trimming nose hairs
Remove (if fi tted) the comb attachment 1) 7/8 from the cutting
head 1.
Slide the on/off switch
2) 3 upwards.
WARNING - RISK OF INJURY
Do not insert the cutting head ► 1 too deeply!
NOTICE
Ensure that your nostrils are clean. ►
Guide the cutting head 3) 1 carefully into the nostril and slowly
turn the appliance so that all nose hair growth is removed.
Withdraw the cutting head
4) 1 out of the nostril whilst turning the
appliance.
Switch the appliance off by sliding the on/off switch
5) 3 downwards.
Trimming eyebrows
Affi x the desired comb attachment (4 mm 1) 7 or 7 mm 8) to the
cutting head 1 so that it is fi rmly seated.
Slide the on/off switch
2) 3 upwards.
To trim all of the hair of the eyebrow, move the comb attachment 3)
7/8 over the eyebrow and against the direction of hair growth.
To trim only individual hairs, move the comb attachment
4) 7/8
over the eyebrow and only against these individual hairs.
In order to trim hair to just above the skin surface, remove the
5)
comb attachment 7/8 and guide the cutting head 1 directly
over the skin in the desired areas.
Switch the appliance off by sliding the on/off switch
6) 3 downwards.
IB_67155_SNHT1.5B2_LB5_k.indb 43 IB_67155_SNHT1.5B2_LB5_k.indb 43 10.06.2011 9:34:53 Uhr 10.06.2011 9:34:53 Uhr