Silvercrest Z30342 - Manual (Page 18)

18 GB/MT
Use / Cleaning and Maintenance / Disposal
wise direction until it is tight (note the markings
on the device).
Q Using of the salt
and pepper mill
j Remove the cover 5 .
j Please keep the button 2 pushed to activate
the salt and pepper mill. The bulb 8 on the
base of the salt and pepper mill will then be
simultaneously activated.
Note: Use the mill only when the container
4 is full and do not leave the mill switched on
uninterrupted for longer than 1 minute so that it
does not overheat. After using the mill for one
minute, let it cool down for at least 3 minutes
before switching it on again.
Q
Adjusting the grinding level
j Turn the adjustable screw 7 clockwise to re-
ceive a finer grinding level.
j Turn the adjustable screw 7 anticlockwise to
receive a coarser grinding level (see fig. C).
Note: If you can no longer turn the grinder
when it is adjusted to very fine, you have to se-
lect a coarser setting. If the grinder still does
not turn, it may be clogged up. Release the ad-
justment screw
7 and take out the grinder.
Clean it, place it back in position and then
retighten the adjustment screw
7 .
Q Recharging the salt / pepper
mill again
j Remove the cover 5 .
j Place the charging station 6 onto a stable and
level surface. Insert the adaptor 12 into the charg-
ing station 6 and then connect it to a socket.
j Place the salt / peppermill with the Silvercrest
logo facing towards the front on the charging
station
6 in order to start the charging pro-
cess. The charging time is approximately 3
hours.
Note: The red LED light on the mill will shine
during the charging process. It will go out when
the rechargeable batteries have been completely
recharged.
Q Replacing the light
Note: Remove the rechargeable batteries before
replacing the light bulb in order to avoid switching
the salt / pepper mill on by accident. Only use light
bulbs of the same type and the same wattage as
you could otherwise damage the mill.
j Turn the salt / pepper mill around so that the
grinder and the lighting
8 are at the top.
j Carefully remove the light bulb from the bulb
socket.
j Insert the new light bulb into the bulb socket.
Q
Cleaning and Maintenance
j The device should only be cleaned on the out-
side with a soft dry cloth.
j Under no circumstances should you use liquids
or detergents, as these will damage the device.
Q
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.