Silvercrest SSM 550 B1 - Manual (Page 10)

- 8 -
Cleaning the mixer
➩
So that you do not injure yourself on the cutters
r , clean the mixer jug e only with a long
handled dishwasher brush.
➩
In a case of stubborn soiling, the mixer jug e
can also be cleaned in a dishwasher. For this,
always take the mixing jug
e apart, as
described later.
➩
Clean the lid w and the filling cap q in a dish-
washer or with the normal washing up.
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
➩
Fill the blender e with 750 ml of water and
add a few drops of mild detergent. Close the lid
w and fit the blender e onto the motor block u .
Insert the plug into a mains power socket and
activate the Ice Crush/Clean operation a few ti-
mes, such that the cutting blade
r ploughs
through the water at full speed.
Afterwards, rinse the blender
e out with lots of
clean water to ensure that all detergent residues
have been removed.
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
e (with the cut-
ters r ) from the the glass part:

Glass element

Sealing ring

Cutting blade

Plastic element
➩
Remove the mixer jug e from the motor block
u .
➩
Turn the plastic element
 of the mixer attach-
ment e anti-clockwise, such that it allows itself to
be released from the glass element
.

Attention!
Take care with the cutters
. They are very sharp.
Risk of injury!
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic part
 of the mixer jug
e
back onto the glass part
. Ensure that the sea-
ling ring
 is correctly fitted.




IB_71495_SSM550B1_LB6 21.10.2011 10:51 Uhr Seite 8