Silvercrest SRHG 15 A1 - Manual (Page 48)

45 SRHG 15 A1
GB
MT
Straightening hair
■ Prepare the hair as described in “Before straightening”.
■ Start with the lower hair pieces at the back of the head. Work over the sides
to the front.
1) Separate a ca. 3 cm wide hair strand.
WARNING - RISK OF BURNS!
► Ensure that you do not touch the scalp or other skin on the body with the
hot plates 4.
► During the procedure you may only take hold of the appliance by the
handle!
2) Clamp the strand of hair close to the scalp between the hot plates 4 and
press them together.
3) Draw the entire strand of hair through the hot plates 4 by pulling the hair
straightener downwards.
4) Repeat the process with each individual strand.
5) When you have smoothed all of the strands, slide the on/off switch 2
to “0”. The control lamp 3 extinguishes.
6) Remove the power plug from the wall socket.
7) Press the hot plates 4 together and slide the restraining device 1 to the
position .
Safety switch off
This appliance is fi tted with a safety switch-off .
After approx. 30 minutes, and without activation of the on/off switch 2, the
appliance switches itself off automatically. After approx. 25 minutes the control
lamp 3 starts to blink, to remind you it is about to switch off automatically.
Should you wish to continue using it for longer than 30 minutes, switch the appli-
ance off and then immediately back on. The 30 minutes start from the beginning
again.
NOTICE
► The safety switch-off is not intended to replace switching the appliance
off manually with the on/off switch 2! It is only for your safety, should you
forget to switch it off !