Silvercrest SSD 3000 A1 - Manual (Page 7)

5 GB
5. If you release the lever4, it must sit
very close to the flat head of the tri-
pod17.
6. Check the tight fitting of the quick
shoe2 within the tripod flat head17.
5.3 Settings at the tripod and
transport
NOTE:
For additional stabilisation, you may use the
hook10 to fasten weights up to 2 kilograms.
Height
WARNING!
After loosening the locking screw6, the centre
axle is released. Therefore, the centre axle, in-
cluding the camera could slide down. So this
can be prevented, hold the handle15 firmly
when loosening the locking screw6.
• Extend the legs9 to the desired length.
• Loosen the locking screw6 and crank
the centre axle upward using the
crank7. Afterwards, retighten the lock-
ing screw6.
Slant upward/downward
• Loosen the long handle15 by turning it
anti-clockwise. Move the handle up or
down. When you are done, tighten the
handle15 by turning it clockwise.
Turn it 360°
• In order to turn the centre axle, loosen
the locking screw5. Afterwards retight-
en the locking screw5.
Tipping the tripod flat head
For pictures in the portrait format tip the flat
head of the tripod.
•
In order to tip the flat head of the tri-
pod17, loosen the locking screw16,
tip the flat head of the tripod to the de-
sired position and retighten the locking
screw.
Transport
• Use the handle to carry the tripod13.
6. Cleaning and
storage
WARNING! Risk of material dam-
age!
•
Do not use any astringent or abrasive
cleaning agents.
• Use a slightly moist cloth to clean the
tripod. If necessary, you may also put
mild soapy water on the cloth.
• After cleaning, let the tripod dry.
• Store the tripod in a dry place using
the tripod bag included in the delivery.
7. Disposal
After the end of service life, the product is to
be disposed of in a proper and environmen-
tally-compatible manner.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
8. Technical
specifications
Subject to technical modification.
Model: SSD 3000 A1
Height:
min:
max:
approx. 62 cm
approx. 158 cm
Max. load: 3 kg
Thread size: 6.35 mm / 1/4 inch
__Toz79831_B4.book Seite 5 Dienstag, 13. November 2012 12:32 00