Silvercrest SRHG 15 A1 - Manual (Page 9)

7 SRHG 15 A1
GB
Straightening hair
Prepare the hair as described in "Before straightening". ■
Start with the lower hair pieces at the back of the head. Work over the sides ■
to the front.
Separate a ca. 3 cm wide hair strand. 1)
WARNING - RISK OF BURNS!
Ensure that you do not touch the scalp or other skin on the body with the ►
hot plates 4.
During the procedure you may only take hold of the appliance by the
►
handle!
Clamp the strand of hair close to the scalp between the hot plates 2) 4 and
press them together.
Draw the entire strand of hair through the hot plates 3) 4 by pulling the hair
straightener downwards.
Repeat the process with each individual strand. 4)
When you have smoothed all of the strands, slide the on/off switch 5) 2
to "0".. The control lamp 3 extinguishes.
Remove the power plug from the wall socket. 6)
Press the hot plates 7) 4 together and slide the restraining device 1 to the
position .
Safety switch off
This appliance is fi tted with a safety switch-off .
After approx. 30 minutes, and without activation of the on/off switch 2, the
appliance switches itself off automatically. After approx. 25 minutes the control
lamp 3 starts to blink, to remind you it is about to switch off automatically.
Should you wish to continue using it for longer than 30 minutes, switch the appli-
ance off and then immediately back on. The 30 minutes start from the beginning
again.
NOTICE
The safety switch-off is not intended to replace switching the appliance ►
off manually with the on/off switch 2! It is only for your safety, should you
forget to switch it off !
IB_71364_SRHG15A1_LB4.indb Abs2:7 IB_71364_SRHG15A1_LB4.indb Abs2:7 13.12.2011 11:56:24 Uhr 13.12.2011 11:56:24 Uhr