Silvercrest 104412-14-01/104412-14-02 - Manual (Page 45)

45 GB/MT
Preparing for use
Inserting / replacing the batteries
Insert the batteries to provide power to the device before prepar-
ing it for use.
CAUTION! Use the indicated battery types only. Failure to ob-
serve this advice may result in damage to the product.
Receiver (see Fig. B):
Remove the battery compartment cover 6 from the back of the
device.
Remove the used batteries, if present.
Insert 3 batteries (1.5 V , type AA).
Note: Ensure correct polarity. This is indicated in the battery
compartment
8 .
Close the battery compartment 8 .
Transmitter:
Remove the holder 12 by pressing the lock 11 from the back of
the transmitter and remove the rubber cover 15 (see fig. C1).
Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V , type CR 2032). The side marked “+”
must face upwards.
Install the rubber cover 15 , close the holder 12 of the transmitter
back on to the back of the device.