Extron electronic 3000 - Manual

Specifications — MKP 10/2000/3000 Series
Control/remote — keypad (MKP 2000, MKP 3000 Series)
Serial control port ........................ (2) RS-232 on (2) 3.5 mm, 3-pole captive screw connectors
Baud rate and protocol ............... Variable (9600 to 115200 baud), 9600 baud (default), 8 data bits, 1 stop bit, no parity
Serial control pin configurations 1 = TX, 2 = RX, 3 = GND
Ethernet control port ................... 1 RJ-45 female connector
Ethernet data rate ........................ 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ......................... ARP, DHCP, ICMP (ping), TCP/IP, Telnet, HTTP, SMTP
client
Default settings ............................ Link speed and duplex level = autodetected
IP address = 192.168.254.253
Subnet mask = 255.255.0.0
Default gateway = 0.0.0.0
DHCP = off
Program control ........................... Extron’s Simple Instruction Set (SIS ™ )
Microsoft ® Internet Explorer, Telnet
General
External power supply ............... 100 VAC to 240 VAC, 50/60 Hz, external, autoswitchable; to 12 VDC, 1 A,
regulated
Power input requirements ......... 12 VDC
MKP 10 MAAP ................ 150 mA
MKP 2000 .......................... 350 mA
MKP 3000, MKP 3000 MAAP
400 mA
MKP 3000 L ...................... 500 mA
Temperature/humidity .............. Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
Rack mount
MKP 10 MAAP ................ No, but mountable to an MAAP mounting frame or faceplate with MAAP
openings
MKP 3000 L ...................... Yes, with optional 2U rack panel, UCM RAAP, part #70-090-14.
Also furniture/lectern mountable.
Other models .................... No, but furniture/wall mountable in a wall box
Enclosure type .............................. Metal
Enclosure dimensions
MKP 10 MAAP
Faceplate ................... 2.8" H x 2.7" W x 0.05" D
(7.1 cm H x 17.8 cm W x 0.13 cm)
Circuit board ............ 2.6" H x 1.6" W x 0.36"
(6.6 cm H x 4.1 cm W X 0.9 cm)
MKP 2000, MKP 3000
Faceplate ................... 4.5" H x 4.6" W x 0.1" D (2 gang)
(11.4 cm H x 11.7 cm W x 0.3 cm D)
Enclosure .................. 2.7" H x 3.4" W x 2.0" D
(6.7 cm H x 8.6 cm W x 5.1 cm D)
Allow at least an additional 1" (2.5 cm) D for connectors and cable.
(Depth excludes connectors.)
MKP 3000 MAAP
Faceplate ................... 4.5" H x 6.4" W x 0.1" D (3 gang)
(11.4 cm H x 16.3 cm W x 0.3 cm D)
Circuit board ............ 2.8" H x 2.2" W x 1.3" D
(7.1 cm H x 5.6 cm W x 3.3 cm D)
1-2 MKP 10 MAAP, MKP 2000, MKP 3000/3000 MAAP/3000 L Remote Control Keypads • Specifications